Resistencia al corte en discontinuidades con diferentes grados de rugosidad
Strength to the cutting in discontinuities with different degrees of roughness

QRCode
Compartir este ítem
Citación
Date
2009-06-01
Author
Camacho Tauta, Javier Fernando
Reyes-Ortiz, Oscar Javier
Nieto Leal, Andrés
Millán Montejo, Sebastián
Rincón Morantes, Fredy
Publisher
Universidad Militar Nueva Granada
Key words
jrc; rugosidad; discontinuidad; triaxial en rocas
Metadata
Show full item recordResumen
En esta investigación se realizaron ensayos triaxiales sobre rocas artificiales elaboradas con un mortero (arena, cemento y agua) de diferente resistencia. Se incluyeron cilindros sin y con una discontinuidad orientada a 60° con respecto al eje horizontal y tres diferentes grados de rugosidad, (pulida plana, pulida ondulada y ondulada). Se determinaron los parámetros de resistencia de las probetas de mortero y se analizó la influencia de los diferentes grados de rugosidad utilizando el criterio de Barton, obteniendo el coeficiente de rugosidad de la discontinuidad.
Abstract
In this research triaxial testings were done on artificial rocks made with a mortar (cement, sand and water) of different strength. Cylinders were made with and without a discontinuity orientated to 60° with regard to the horizontal axis and three different degrees of roughness, (polished flat, polished wavy and wavy). The mortar testing strength parameters were obtained and was analyzed the influence of the different roughness degrees by the Barton’s criterion, obtaining the roughness coefficient of the discontinuity.
Enlace al recurso
https://revistas.unimilitar.edu.co/index.php/rcin/article/view/310https://doi.org/10.18359/rcin.310
Fuente
Ciencia e Ingenieria Neogranadina; Vol. 19 No. 1 (2009); 55-70Ciencia e Ingeniería Neogranadina; Vol. 19 Núm. 1 (2009); 55-70
Ciencia e Ingeniería Neogranadina; v. 19 n. 1 (2009); 55-70